To fasten the harness correctly is key to restrain the child well in the car seat. You need to pull the harness adjuster strap until the harness is close the the child's body. If the harness is correctly tight, you should be able to pass only 1 finger between your child's body and the harness strap. The tighther the harness is, the better your child will be restrained and the safer he/she is in case of an accident.

The Mobi XP has convenient belt hooks that keep harness and buckle pad conveniently out of the way to easy get the child in and out.

Remove the Maxi-Cosi Mobi XP from the car before carrying out any of the following. The seat may be cleaned with lukewarm water and a gentle soap. Do not use abrasive detergents. The cover and the belt pads must be washed by hand at a maximum temperature of 30oC. Do not use a dryer. Also see washing instructions on the label sewed to the Mobi XP cover. The belt buckle may be cleaned with warm water. Do not lubricate.

The correct belt height of the shoulder belts is attained when the belt disappears into the shell slightly above the shoulder of the child. Make sure that the shoulder belts fit properly over the shoulders of the child. Please consult the manual for a visualization of these steps: Loosen the shoulder belts by pressing the release button and pulling the shoulder belts towards you as far as possible. Lift up the flap on the cover by the shoulder belt slots. To make the adjustment easier, pull the shoulder belts on top of the belt pad forward into a loop, loosening them. Next, push the loop back through the opening. Slide the shoulder belt and the belt pad strap through the slot together into the next position. Make sure that the shoulder belt is positioned on top of the belt pad strap in the new position. Always do this on both sides. Pull the shoulder belts tight by pulling on the belts under the belt pads. Place the flap back in position and thread the belt pads through the correct slots in the flap and secure them with the Velcro. Check whether you are able to use the belts and ensure they are not twisted.

Esto puede estar causado por un pasaje incorrecto del sistema de arneses. Comprueba que los tirantes del arnés no están retorcidos en ninguna parte del recorrido. Verifica también que los tirantes pueden moverse libremente a través de las ranuras de los hombros y que la hebilla de cierre se puede echar completamente hacia atrás. La hebilla de cierre del cinturón funciona liberando el tensor de la correa. Si el problema continúa después de haber comprobado esto, consulta con tu comercio de puericultura.

En ese caso nosotros te aconsejamos, al igual que todos los expertos internacionales en seguridad, que pares de inmediato en un lugar seguro, que vuelvas a ajustar el arnés al niño y que le inculques que eso no se puede hacer, explicándole de forma comprensible por su parte, el por qué. Y es que no se puede descartar que un niño inventivo, hábil o simplemente fuerte consiga abrir el cierre del arnés. Aumentar la resistencia a la apertura del cierre para impedir que el niño consiga abrirlo va en contra de las normas legales de seguridad. Así, en todas las normas europeas se establece el lugar donde debe estar el cierre, el color del botón y la fuerza de apertura o manejo. Cualquier persona que acuda a ayudar en caso de accidente y que no tenga experiencia con sillas de auto deberá poder liberar fácilmente al niño, si fuese necesario.

The child's head has to be totally protected and should not exceed the headrest.

The harness straps should be placed at the level of the shoulders, not coming from above nor below. The headrest should be adjusted in consequence, keeping the harness at the level of the shoulders.

Yes. Each time you install your child in the car seat you should fasten the safety harness. This is because the child can wear different clothing. If the harness is correctly tight, you should be able to pass only 1 finger between your child's body and the harness strap.